STL file Gummy Bears Mold 🐻・3D print model to download・Cults

May 05,2024

If you love gummy bears, as I do, then you.
If you love gummy bears, as I do, then you'll love this design! It's a mold so you can make your own big-size gummi bears! (It's about 20 normal-sized gummi bears together). The mold is divided into two parts, is easy to print and doesn't waste much material either. To join it you need 2 of that kind of pin that you get in the bookcases (I leave an image to guide you) and 2 screws of 5 cm long, with a nut to adjust the mold better and avoid spilling the content through any hole left (4.4 mm wide) And I also leave you the recipe already tested by me, which worked deliciously well. Recipe: -10 to 15 normal gummi bears (more intense the flavor) -3 to 5 teaspoons of grenetine (no flavor), same amount of water for hydration (the amount may vary from the final flavor) -microwave everything together -turn in the previously buttered mould and send to the fridge. 30 minutes of cold and it will be ready to remove from the mold. Any question you can write me or contact me by IG @Jay.3d_ ----- If you love gummy bears, just like I do, then you will love this design! It is a mold to make your own large gummy bears! (They are about 20 normal-sized bears together approximately). The mold is divided into two parts, it is easy to print and it does not waste much material either. To join it, you need 2 of that kind of brooch that you can get in bookstores (I leave an image to guide you) and 2 screws 5 cm long, with a nut to better adjust the mold and prevent the content from spilling for some reason. gap left (4.4 mm wide) And I also leave you the recipe already tested by me, which worked deliciously well for me. Receive: -from 10 to 15 normal gummy bears (the more quantity the more intense the flavor) -3 to 5 teaspoons gelatin (unflavored) the same amount of water to hydrate (in the same way the amount can vary the final flavor) -Melt in the microwave all together -Pour into the previously greased mold and send to the fridge. Cold approx 30min and it will be ready to unmold. Any questions you can write me or contact me by IG @ Jay.3d_